Sandpiper MSB2-B User Manual

Model MSB2 ©Copyright 2014 IDEX AODD, Inc. All rights reserved.Table of ContentsPrinciple of Operation ...

Model MSB2 Page 8 msb2dl3sm-REV0614000 Assembly, sub-assembly; and some purchased items010 Cast Iron012 Powered Metal015 Ductile Iron020 Ferri

msb2dl3sm-REV0614 Model MSB2 Page 9 ITEM TOTAL NO. PART NUMBER DESCRIPTION RQD. 1 070-006-170 Bearing, Sleeve 2 2 114-002-156 Bra

Model MSB2 Page 10 msb2dl3sm-REV0614ITEM TOTAL NO. PART NUMBER DESCRIPTION RQD. 33 050-017-365 Ball, Check Valve 4 050-017-360 Ball,

msb2dl3sm-REV0614 Model MSB2 Page 11

msb2dl3sm-REV0614 Model MSB2 Page 1 PRINCIPLE OF PUMP OPERATION This ball valve pump is powered by compressed air and is a 1:1 pressure ratio desig

Model MSB2 Page 2 msb2dl3sm-REV0614AIR INLET & PRIMING For start-up, open an air valve approximately 1/2" to 3/4" turn. After the uni

msb2dl3sm-REV0614 Model MSB2 Page 3 To re-install the sleeve and spool set, lightly lubricate the o-rings on the sleeve with an o-ring assembly lu

Model MSB2 Page 4 msb2dl3sm-REV0614REASSEMBLY All procedures for reassembling the pump are the reverse of the previous instructions with further in

msb2dl3sm-REV0614 Model MSB2 Page 5 PROBLEM: Pump will not cycle. (Note: Always disconnect air supply to relieve air pressure before disassembling a

Model MSB2 Page 6 msb2dl3sm-REV0614IMPORTANT SAFETY INFORMATIONIMPORTANTRECYCLING Many components of SANDPIPER® AODD pumps are made of recyclable

msb2dl3sm-REV0614 Model MSB2 Page 7 PUMPING HAZARDOUS LIQUIDSWhen a diaphragm fails, the pumped liquid or fumes enter the air end of the pump. Fumes