Sandpiper X02 User Manual download pdf (Page 5)

e02x02mdl4sm-rev0614 Page 5

This pump is pressurized

internally with air pressure

during operation. Always

make certain that all bolting

is in good condition and

that all of the correct

bolting is reinstalled during assembly.

WARNING

Before pump operation,

inspect all gasketed

fasteners for looseness

caused by gasket creep. Re-

torque loose fasteners to

prevent leakage. Follow recommended torques

stated in this manual.

CAUTION

When used for toxic or

aggressive uids, the pump

should always be ushed

clean prior to disassembly.

WARNING

IMPORTANT

Read these safety warnings

and instructions in this

manual completely, before

installation and start-up

of the pump. It is the

responsibility of the purchaser to retain this

manual for reference. Failure to comply with

the recommendations stated in this manual will

damage the pump, and void factory warranty.

WARNING

Airborne particles and loud

noise hazards.

Wear ear and eye protection.

WARNING

CAUTION

Use safe practices

when lifting

Pump not designed,

tested or certied to be

powered by compressed

natural gas. Powering

the pump with natural

gas will void the warranty.

Before doing any

maintenance on the pump,

be certain all pressure is

completely vented from the

pump, suction, discharge,

piping, and all other

openings and connections. Be certain the air

supply is locked out or made non-operational,

so that it cannot be started while work is being

done on the pump. Be certain that approved

eye protection and protective clothing are worn

all times in the vicinity of the pump. Failure to

follow these recommendations may result in

serious injury or death.

WARNING

WARNING

In the event of diaphragm

rupture, pumped material

may enter the air end of the

pump, and be discharged

into the atmosphere. If

pumping a product which is hazardous or toxic,

the air exhaust must be piped to an appropriate

area for safe disposition.

IMPORTANT SAFETY

INFORMATION

Before maintenance or

repair, shut off the com-

pressed air line, bleed the

pressure, and disconnect

the air line from the pump.

The discharge line may be

pressurized and must be bled of its pressure.

WARNING

RECYCLING

Many components of SANDPIPER

®

Metallic AODD pumps are made of

recyclable materials. We encourage

pump users to recycle worn out parts

and pumps whenever possible, after

any hazardous pumped fluids are

thoroughly ushed.

Pump complies with EN809 Pumping

Directive, Directive 2006/42/EC Machinery,

according to Annex VIII.

kg

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments